Limited Time Offer!
Selling Price -INVOICE - Call for quote!
Selling Price -
INVOICE - Call for quote!
2023 John Deere 2 Series 2025R
*REDUCED CASH PRICE FOR A LIMITED TIME! - through January 31st, 2024
Restrictions apply. Must reside in dealer area for sale price redemption. See dealer for details.
- Hydro transmission with TwinTouch™ pedals for ease of use
- AutoConnect™ mid-mower deck can be installed or removed in less than 5 minutes
Features may include:
Durable, efficient, high-torque 3-cylinder diesel engine provides adequate power
- Power is provided by a durable and efficient high-torque three-cylinder Yanmar® TNV Series diesel engine.
- This series of engines was developed to meet Tier 4 Environmental Protection Agency (EPA) environmental requirements by featuring low levels of both exhaust and emissions.
- YANMAR TNV SERIES ENGINE OFFERS THESE FEATURES:
- Economical for good cooling and long life
- Isolated engine provides reduced vibration and noise for the operator; indirect fuel injection uses a precombustion chamber to give the engine a smooth and quiet operation; aluminum-alloy piston with built-in steel struts are lightweight to reduce connection rod bearing loads and provide good heat transfer characteristics
- Design permits tighter tolerances and neutralizes expansion of the piston, thereby reducing blow-by gas and less noise from the piston slap
- Higher top rings on the piston and a thinner head gasket greatly reduces the volume of unburned waste gases and increases combustion efficiency
- Timing-gear teeth have a designed roll-off profile giving almost no clash, no noise, and no backlash
- High-torque reserve provides plenty of power under heavy load, yet retains excellent fuel economy
- Easy access to engine check and fill points on the right-hand side of the tractor by removing the side panels
- Fuel filter with replaceable element
- Full-pressure lubrication system provides filtered oil under pressure to all vital engine parts
- Glow plugs provide quick starts in temperatures down to -18°C (0°F)
- Auto-bleed fuel system means there is no special bleeding required if the tractor runs out of fuel; this system will self-prime the injection pump, lines, and injectors, providing fast fuel recovery
- Key start and shut off eliminates fuel shut-off knob
- Electric solenoid shuts fuel supply off immediately when key is turned off
- See-through coolant recovery tank permits operator to check coolant level without removing radiator cap
- Dry-type air cleaner with safety element keeps dirt and other contaminants out of the engine
- Safety element (second filter) will protect engine if primary filter would develop a leak
- Protects engine when servicing primary filter
- Air filter restriction indicator is standard equipment on the 2025R Tractor
- Sealed-radiator compartment keeps trash and debris on outside of hood
- Horizontal exhaust discharges fumes away from the operator station, reducing noise and improving operator visibility and comfort
The 2R Series are equipped with a two-range hydrostatic transmission (HST) incorporated in a die-cast aluminum transmission case. Fluid under pressure transmits engine power to the drive wheels via a closed-loop pump and motor arrangement. Infinite ground speeds allow the operator to match the speed of the tractor to the job.
- No clut
- 2023
- John Deere
- 2 Series
- 2025R
- Compact
- Model: 3TNV80F-NCJT
- Yanmar®
- SAE J1995 rated power: 23.9 hp (17.8 kW) / 24.2 PS at 3200 rpm
- 3200 rpm
- Natural
- Final Tier 4
- Three | Cast-in-block
- 77 cu in. (1.267 L)
- 3.2 in (80 mm)
- 3.3 in. (84 mm)
- Pressurized
- Water pump
- Dual element
- At rated speed: 39.1 lb-ft (53.1 Nm)
- Power take-off (PTO) power: 17.2 hp (12.8 kW) | Rear - 540 rpm / Mid - 2100 rpm
- Indirect injection
- Diesel
- 23.1:01
- Indirect injection
- Hydrostatic - two range
- Spur gear
- Power steering
- Wet disk
- Wet disc
- R3 Turf: 23x8.50-12 / R3 Radial: 220/55-R12 / R4 Industrial: 23x8.50-12
- R3 Turf: 12-16.5 / R3 Radial: 280/70 R16 / R4 Industrial: 12-16.5
- 500 CCA
- 40 amp
- Starter size: 1.6 hp (1.2 kW)
- Remote control valves available: Two
- Steering: 3.5 gpm (13.25 L/min) | Implement: 3.5 gpm (13.25 L/min) / 7.0 gpm (26.5 L/min)
- 1987 psi (137 bar)
- Gear
- Limited Category 1
- 63 in. (1600 mm)
- Without brakes: 8.2 ft (2.51 m)
- 5.39 gal. (20.4 L)
- 1349 lb (612 kg)
- 2425 lb (1100 kg)
- 24-in. behind link arms: 915 lb (415 kg)
- Platform - flat/straddle: Three-piece semi flat | Gear shift location - console/floor: Left-hand side
- Open station: 1872 lb (849 kg) / Cab: 2392 lb (1085 kg)
- $27,524.00
- Tunkhannock
- New
- 50763
- 2023
- John Deere
- 2 Series 2025R
- Model: 3TNV80F-NCJT
- Hydrostatic - two range
- Diesel
- Available